Most popular

Does hydrofoil help hole shots?

by Lennon Wade

Does hydrofoil help hole shots?

In the end, an outboard only has a one speed gearbox, so don’t rule out a hydrofoil. If set up correctly, it will lower the holeshot time considerably, and cause no loss of top speed, as it’s out of the water when on the pad.

What does plugging holes in prop do?

The idea of the plugs is to allow the engine exhaust gases to blow bubbles across the blades of the prop when first starting to cause the prop to vent and unload. Then, as the boat begins to move, the prop will gradually begin to hook up. If you need the total best hole shot, then removing the plugs is right for you.

Do pvs plugs affect top speed?

the plugs shouldn’t do anything to top rpm or speed. it aids in getting the prop to spool up at initial throttle up.

How can I improve my boat performance?

  1. Modifying Your Outboard Engine Can Lessen Reliability.
  2. Trimming Your Engine Loses Efficiency.
  3. Try Different Props to Maximize Performance.
  4. Get Rid of the Roostertail Behind the Boat.
  5. Get a Jack Plate for Your Outboard Engine.
  6. Get Advice from Other Boaters with Your Same Engine.

What is mercury PVS?

The Performance Vent System, designed and patented by Mercury marine, is a management system of the exhaust gases that exit from the propeller’s tube allowing us to control the venting of the propeller blades in order to optimize the acceleration for quick planing. …

What is performance vent system?

Performance Vent System. The performance vent system (PVS) was created to help our customers optimize Mercury Propellers on their personal boat and unique boating conditions. PVS allows the boater to custom tune the venting of the propeller blades to dial in the perfect acceleration and cruising performance.

What are prop vents?

Why does my boat take forever to get on plane?

Here’s why a boat struggles to get on a plane or won’t plane at all. A boat won’t plane out either due to a bad propeller, improper motor placement on the transom, wrong trim position, uneven weight distribution in the boat, low engine performance.