How do I access my tp link load balancer?

Choose the menu Transmission> Load Balancing > Basic Settings to load the configuration page. Enable Load Balancing globally, and click Save. Enable Application Optimized Routing, and enable Bandwidth Based Balancing Routing on WAN1 port and WAN2 port. Click Save.

How do I reset my TL R480T+?

For TL-R480T+ V7 version go to Maiantanance- Management

1. Export and Import tab.
2. Press the Export button to save the configuration file to drive.
3. Go to import browser config file and press the restore button to restore settings from the backup.

How do I load a TP Link?

Setup the Hardware

1. Unpack the TP-Link router and screw on the external antennas (if the unit has them).
2. Turn off your computer’s Wi-Fi, if it is on.
3. Plug the Ethernet cable into one of the switch ports (usually yellow in color), then plug the other end of the cable into your computer’s Ethernet port.

How do I set up my TL ER5120?

For the TP-LINK TL-ER5120, you have to do the following steps for access:

1. Put router into operation.
2. Connect the device and router.
3. Start web browser.
4. Enter IP address in the address bar and then confirm with ‘Enter’ key.
5. Enter username and password in the open interface and confirm once more.

How do I connect my TP-Link to my computer?

Power on your router and computer first and then modem.

1. Log into the router’s web-based management page.
2. Configure WAN Connection Type.
3. Enter your PPPoE username and password which are provided by your ISP.
4. Click Save to save your settings, then the router will connect to Internet after a while.

How do I set up my TL ER6120?

For the TP-LINK TL-ER6120, you have to do the following steps for access:

1. Put router into operation.
2. Connect the device with router.
3. Open web browser.
4. Enter IP address in the address bar and then confirm with ‘Enter’ key.
5. Enter username and password in the open user interface and confirm again.