How do I enable SNMP on HP ProCurve Switch?
How do I enable SNMP on HP ProCurve Switch?
How to enable SNMP on a HP Procurve device
- Telnet, SSH, or serial (console) into your Procurve device with a manager account.
- Enter configuration mode by typing: configure terminal.
- Issue the following commands: snmp-server enable snmp-server community community_string.
How do I manage my HP ProCurve switches?
How to: Configure a HP ProCurve switch
- Step 1: Connect your serial connection.
- Step 2: Conenct PuTTY.
- Step 3: Get the IP address.
- Step 4: Set time server.
- Step 5: Set SNMP community info.
- Step 6: Launch the web GUI.
- Step 7: Configure basic info.
- Step 8: Create VLANs.
How do I turn off HP ProCurve Switch?
The most graceful way to shutdown an E-series Procurve switch is to do a “write memory” command at the CLI, (alternately exiting the menu interface or committing a change on the WebUI), wait for the command to complete, then pull the plug. If you want to reboot, you can do a “reload” or a “boot” command.
How do I enable SNMP on HP printer?
To enable HP Web Jetadmin to discover and manage devices using SNMPv3, go to Tools > Options > Device Management > Device Discovery, enable Discover SNMPv3 devices, and click Apply.
What is the default SNMP port?
161
The default SNMP port number is 161. snmp-agent-protocol—The protocol the SNMP agent will communicate with. The default protocol is UDP. system-contact—The contact information for this sensor.
Do HP switches have a lifetime warranty?
HP is offering a lifetime warranty on the device, which the company defines this way: “For as long as a product is owned, with next-business-day advance replacement (available in most countries).” Switch owners will be entitled to “standard next business day advanced-replacement (availability varies by location) with …
How do I put my HP switch into control mode?
Configuration commands and the context configuration modes
- HP Switch(config)# interface c3-c6. HP Switch(eth-C5-C8)#
- HP Switch(eth-C5-C8)# HP Switch(eth-Trk1)#
- HP Switch(config)# vlan 100. Command executed at configuration level to enter VLAN 100 context.
- HP Switch(vlan-100)#
- HP Switch(vlan-100)#?
How do I reset my HP ProCurve Switch?
To initialize, or reboot, a ProCurve Switch, perform the following steps:
- Press the small, recessed Reset button on the face of the switch.
- Issue the command, reload from within the CLI.
- Or, issue the command, boot system flash to reboot into either primary or secondary flash.
How do I check my ports on my HP switch?
To check the mode setting for a port on the switch, use either the Port Status screen in the menu interface or show interfaces brief in the CLI (see Viewing port status and configuration (CLI)).