How do I identify my Dodge transmission?

How do I identify my Dodge transmission?

Transmission identification numbers are stamped on the driver side of the case flange just above the oil pan gasket (just below the TV lever). There will be a 9 digit part number, a space, a 4 digit build date, a space, and a 4 digit serial number. 6 = strength of trans. (1-9, higher number, stronger trans.)

How do I identify my manual transmission?

Essentially, if you must shift gears yourself, you have a manual transmission. But if you place your car into drive or reverse to make it move, the transmission is an automatic. So if your car doesn’t have a clutch pedal, it has an automatic transmission.

How do I identify a Borg Warner t19 transmission?

Locate the identification tag number. A quick way to confirm that your transmission is a Borg Warner and what vehicle it was designed for, is to locate the identification number stamped into the “metal tag bolted onto the tail housing,” according to 5speeds.com.

How do I identify a Chevy 5 speed transmission?

How Do I Identify Manual Transmissions on Chevy 1988 -1992 Trucks?

  1. Look for the manufacturer’s tag, usually attached to a bolt on the transmission extension housing. This tag identifies the manufacturer and the model transmission.
  2. Inspect the transmission for visual characteristics.

Is the 68RFE a good transmission?

The 68RFE is a well-designed and strong transmission with gear splits suited to the normal load-moving tasks faced by heavy-duty Ram diesel pickups. But it’s not strong enough to handle the high-output Cummins if one is towing at or near the maximum rating of a Ram 3500 day in and day out.

Can I tell what transmission I have by the Vin?

Simply write the VIN number down and you can then ask a dealership service department, auto repair shop, or auto parts retailer to help you identify the transmission. They’ll easily be able to find the specs by plugging the VIN number into the computer.

What is a M21 transmission?

The M21 & M22 is a four speed, RWD or 4WD transmission. The M21 & M22 is a Muncie engineering design, this transmission is aluminum case, extension housing and side cover. The side cover has seven bolts and two shift cams. The synchro rings have 35 teeth and the unit has a 4 step cluster gear.

What is the difference between a T18 and T19 transmission?

T19 versions offer a 6.32:1 (IH), 5:1 or 4:1 (Ford) low gear. The T18 is synchronized in the second through fourth gears. All gears are helically cut except first and reverse, which are spur gears. T19s are fully synchronized in all gears and feature all helically cut gears.

How do I know what Borg Warner 4 speed transmission I have?

The easiest way is by knowing the construction of each unit, and the differences are obvious. If the case and side cover are made of cast iron, that would make it a Saginaw transmission. If it has a cast-iron case with an aluminum side cover and tail housing, that will mean you have found a Borg Warner.

How can I tell if I have a NV3500 or nv4500?

Thus, the quick way to ID which transmission you’re dealing with is to note whether the bellhousing is a separate piece (4500) or integrated (3500). In addition, the lighter-duty 3500’s case/bellhousing is all aluminum, whereas the heavy duty 4500 uses an aluminum bellhousing but a cast iron transmission case.

How do I identify a GM 5 speed manual transmission?

This 5-speed is based on the T4 Design. Aluminum case with top cover, internal single-rail shift with the shifter mounted on the extension housing. Casting numbers on the case, cover or extension housing are 13-51 or 13-52. 5th gear (overdrive) is located at the rear of the transmission in the extension housing.