How do I reset my Linksys wireless-G access point?

Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle. Unplug the access point’s power cable and wait for 30 seconds then plug it back in.

How do I reset my Linksys Wireless-G?

QUICK TIP: For router models such as the Linksys Wireless-B and Wireless-G routers, press and hold the Reset button for 30 seconds. QUICK TIP: Observe the Power light of the router while pressing the button. It should blink or flash as an indication that the router is properly resetting.

What are the default settings for the Linksys wap54g router?

Factory Default Settings for the LINKSYS WAP54G wireless router. IP Address. 192.168.1.245 Load Admin. Username. Password. admin. SSID. linksys.

How do I configure a wap54g Wireless-G bridge?

This feature only works with another Wireless-G Access Point (model number: WAP54G). To configure a Wireless Bridge environment, select Wireless Bridge, and enter the MAC addresses of the wireless bridges/access points in the Remote Wireless Bridge’s LAN MAC Addressesfields.

What is the copyright and trademarks of wap54g?

WAP54G (EU/LA/UK) User Guide WIRELESS GHz 2,4 802.11g Wireless-G Access Point Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2005 Cisco Systems, Inc. All rights reserved.

How do I short the flash memory pins on a wap54g?

Short the flash memory pins 15 & 16 using the Linksys WRT54G Revival method. Tested on a WAP54G v3.1: locate the flash memory located on the circuit board bottom. Shorting the pins with a paperclip should enable pings and web interface access.