How do you reset a wall heater?
How do you reset a wall heater?
Electric Heaters For new wall heaters, turn the dial towards ‘Pilot’ and press down on the ‘Ignite’ button. You will have to press the button, again and again, until the pilot light starts from the spark. When the pilot light starts, continue holding the button for about a minute. Then, release it.
How do I light my wall heater pilot?
Locate the pilot light vent’s location. Push down on the selector dial to generate a small flow of gas. Ignite the pilot light with a long match or a long-barrel lighter. Once the pilot light is lit, turn on the heater and verify that it’s working.
Why won’t my pilot light stay lit on my furnace?
If your pilot light won’t stay alight, it might be the thermocouple. Sometimes dust buildup collects on the thermocouple and blocks the sensor. Try cleaning the thermocouple and then relighting the pilot light. If it continues to go out, the thermocouple might need to be replaced.
Should the pilot light always be on in a gas furnace?
Most furnaces with electronic ignition have a device called a hot surface igniter. The difference is that the flame is only lit (by an electronic spark) when your furnace is ready for a heating cycle. When the pilot light is not needed, it is completely off, saving you money on gas.
Why does wall heater keep turning off?
If your furnace keeps shutting off, it could be due to low airflow. There are several indirect issues that cause low airflow. Dirty Air Filters. If you don’t change your air filters often enough, the filters will become dirty and clogged, which means the heat exchanger retains heat and eventually causes it to overheat.
Why does my gas wall heater keep turning off?
Why does my pilot light keep going out on my wall heater?
A faulty, misaligned, dirty, or damaged thermocouple is often the culprit behind your pilot light going out. The thermocouple is an automatic safety shutoff device that prevents the gas valve from opening if the pilot light is out.
Why choose coopercozy heaters?
Cozy Heaters use the highest quality components and constructed by expert American craftsmen, we take pride in each and every product we produce.
How do I get parts for my Cozy heater?
For prompt parts service, contact the wholesaler from which you purchased your Cozy heater. NOTE: Parts & schematic drawings on current models are shown at: www.cozyheaters.com SEE PILOTS ON PAGE 23 SEE GAS VALVES ON PAGE 23 SEE ORIFICES ON PAGE 23
What is the maximum wall thickness for a dual wall heater?
ROUGH-IN INSTRUCTIONS NOTE: Maximum wall thickness for a dual wall (W505, W506) installation is 5-3/8”. STEP 1. Attach the base plate (purchased with the vent pipe) to the header plate using two No. 8 sheet-metal screws through the pre-punched holes. The heater may not vent properly without a base plate to anchor and seal the vent system.
How do you mount a heater on a 2×4?
G) Heater must be installed with legs resting on the 2×4 floor sill plate (recessed) or the factory FSK Kit (flush mount). The header plate shall then be installed at a height 65-3/4 inches above top surface of the plate that the heater legs rest on.