How much does it cost to replace a EGR valve on a Ford Focus?

Ford Focus EGR Valve Replacement Cost Estimate. Labor costs are estimated between $87 and $109 while parts are priced between $121 and $138.

Where is the EGR valve located on a Ford Focus?

Open the hood of the Focus. Notice the EGR valve, which is a circular valve located on the engine intake manifold. It is secured in place by bolts.

How long does it take to replace the EGR valve?

How long does an EGR valve replacement take? Looking once again at the averages delivered by our data, an EGR valve replacement should take around 3/4 of an hour.

How much does it cost to change EGR valve?

The average cost of replacing the EGR valve in your vehicle is anywhere from $250 to $350 on average, depending on your vehicle’s year, make, and model as well as the type of system it has. The cost of parts will be somewhere around $190 to $270, while the cost of labor will be anywhere from $60 to $80.

What happens if EGR valve fails?

A faulty EGR valve can cause problems with the flow and operation of the EGR system leading to performance issues including a reduction in power, reduced acceleration and decreased fuel efficiency. EGR valves can become stuck ‘open’ or ‘closed’ due to a build-up of soot particles, carbon deposits and dirt from fuel.

What are some of the Ford Focus exhaust gas recirculation valve problems?

The exhaust gas recirculation valve is part of your Ford Focus emission control system. It allows emission gases to enter the intake manifold at specific driving conditions. It is common for the valve passages to clog and the valve stem to bind. These problems may be fixed, but worn and broken components make it necessary to replace the valve.

How do you install an EGR valve on a Ford Ranger?

Install the EGR valve using a new gasket. Connect the pipe fitting and mounting bolts by hand first; then tighten and secure the valve to the engine with a wrench or ratchet. Repeat step 3 and make sure the valve stem moves; if not, replace the valve.

How do you fix an EGR valve that is not working?

Turn off the engine. If the valve stem does not move, go to step 5. Disconnect the vacuum line from the top of the EGR valve and block the line using a Phillips screwdriver. Connect a hand vacuum pump to the top of the valve and start the engine. As you apply the vacuum to the valve with the hand pump, the engine should miss or stall.

How do you clean the EGR valve on a Honda Accord?

Follow these steps to troubleshoot the valve and clean it of possible obstructions. Park your car in a safe place, start and warm the engine to operating temperature, then turn off the engine. Open the hood and remove the air cleaner assembly to reach the EGR valve. Start the engine again.