How much HP can a b230 handle?
How much HP can a b230 handle?
A b230ft block with good rods ,pistons and crank will hold for 600-700hp. Its depends much of how much cylinderpressure and heat the engine produce. Over 600-700hp the block needs some smaller modifications to hold.
What Volvos had the red block?
Introduced in 1988 for the 740 GLE (and later used in the 940/960), The 16-Valve Redblock motors were offered in both a 2.0–litre Turbo (B204FT/GT) and a 2.3–litre 155 PS (114 kW) Naturally aspirated version (B234F). The head was designed for Volvo by either Cosworth or Porsche.
How much does a B230FT weigh?
With a fuel consumption of 10.5 litres/100km – 27 mpg UK – 22 mpg US (Average), 0 to 100 km/h (62mph) in 9.3 seconds, a maximum top speed of 127 mph (205 km/h), a curb weight of 2976 lbs (1350 kgs), the 940 2.3 Turbo has a turbocharged Inline 4 cylinder engine, Petrol motor, with the engine code B230FT.
How much boost can a b230ft take?
You’ll be fine at 15 psi with a good tune-up and good gas… may run into heat-soak issues (small turbo getting too hot)……
What does red block mean?
Red Block is an extension to block users from Twitter. It can use as replacement of Twitter Block Chain. It can blocks followers/followings, or block retweeters/likers to specific tweet.
How much does a Volvo b230 weigh?
A b230 exchange engine (complete except for accessories and manifolds.) weighs 310 Pounds. If you have a the m46 your total weight (gear box, overdrive, shifter, and bell housing) is 120 pounds.
How much does a Volvo 240 engine weigh?
This engine produces a maximum power of 113 PS (111 bhp – 83 kW) at 5400 rpm and a maximum torque of 183 Nm (134 lb….
| Volvo 240 Wagon (245) 2.3 Size, Dimensions, Aerodynamics and Weight | |
|---|---|
| Curb Weight : | 1305 kg OR 2877 lbs |
| Weight-Power Output Ratio : | 11.5 kg/hp |
How much boost can a stock Saab 9 3 handle?
The stock turbo itself can go up to 18 pounds of boost but you need a boost control for that and also if you are going to run 18 pounds of boost you would nheed to redo your timing and customize your manifold etc to accompany the extra horsepower or your engine will blow extremely easily.
How many valves does a Volvo B234 have?
i.e. B230 (SOHC, 2.3 litres), B234 (2.3 litres, DOHC * 4 valves per cylinder * 4 cylinders = 16 valves) The following suffixes were commonly used by Volvo:
What kind of engine does a Volvo B21 have?
The Volvo B21 is a slant straight-four engine first used in the Volvo 200 series, meant to replace the B20. The B21 and all derived engines are often referred to as red block engines for the red paint applied to the block.
What is the difference between b230et&B230FT?
Marked ‘H’ 13 mm cross section. Marked ‘M’ The B230FT OEM piston is “dishier” at 4.5 mm deep VS the B230ET at 3.6 mm deep therefore higher compression Shows a comparison between B21 & B230 cranks. Not shown is 85-88 low friction crank where thrust bearing is in centre, rather than end.
What is the difference between a B19 and B23 engine?
The engines are tilted approx 15 degrees to left (exhaust side) to make room for the more complicated injection systems. B19 and B21 blocks can be identified by water plugs on one side of the block. The B23 blocks have them on both sides. The camshaft is driven by a toothed belt that is driven off the front of the crankshaft.