What does service engine soon light mean on Mitsubishi Eclipse?

Flashing service engine soon light means that there is an engine misfire, which in most cases is caused by a faulty spark plug or bad ignition coil.

How do you turn off the service engine soon light on a Mitsubishi Eclipse?

Turn off the ignition key. Disconnect the battery cables from the battery located on the front passenger’s side of the engine compartment. Loosen the 10 mm battery cable end bolt with a 10 mm wrench and twist while pulling the cable from the terminal. Repeat for the positive cable end.

How do you reset service engine soon light?

The only way to keep the light off is to repair the problem that turned the light on before attempting to turn it off.

1. Turn the ignition switch to the on position but do not start the car.
2. Count seven seconds, depress the gas pedal and hold it down for 10 seconds or until the service engine soon light begins flashing.

How do you reset the oil life on a 2012 Mitsubishi Eclipse?

Mitsubishi Eclipse Cross Routine Maintenance Required Service Reminder Light Reset

1. Turn Ignition OFF.
2. Press the UP BUTTON to navigate WRENCH-MILES-MONTH on the display.
3. While the wrench is flashing press again the page button to display CLEAR.
4. Then press again the Page button.

How urgent is the service engine soon light?

Depending on the type of car you drive, the service engine soon light could simply indicate what the name says: you are a week or so past the car’s next scheduled oil change. That might not be too urgent. However, it could also mean the car’s oil level has dropped critically low, so have it checked as soon as possible.

What are some common problems with the Mitsubishi check engine light?

The most common problems that trigger the Mitsubishi check engine or service engine’s soon light are faulty oxygen sensor, dirty mass airflow sensor (MAF), worn spark plugs, bad ignition coil, and loose gas cap. There are hundreds of possible issues that can turn on the check engine light on a Mitsubishi vehicle.

What does service engine soon mean on a Mitsubishi?

Mitsubishi’s service engine soon, also known as a check engine light, can come on when the On-Board Diagnostic (OBD) system detects a problem with the engine, emission system, and/or transmission. If your Mitsubishi check engine light stays on, first check that the gas cap is on tight.

How do you read a check engine light on a Honda?

When the check engine light comes on, a trouble code will be sent to the ECU. Use an OBD-II scanner to read the codes via the diagnostic port under the driver’s side dashboard. Plug an OBD-II scanner into the diagnostic port under the dashboard. Turn on the ignition but don’t turn on the engine. Turn on the scanner and select Read Fault Codes.