Where is the blend door actuator on a 2006 Silverado?

The 2006 Chevrolet Silverado is actually fitted with two different blend door actuators; one is located on the driver’s side, and one is located on the passenger’s side.

How do you reset the blend door actuator on a 2005 Chevy Silverado?

To reset the 2005 chevy silverado door actuator you must remove the 10a hvac 1 fuse with the key off, wait for a few minutes and then reinstall the fuse.

Where is the blend door actuator located on a 2007 Chevy Silverado?

The blend door actuator is typically located closer to the heater core and evaporator than the mode door.

Where is the blend air door actuator located?

The blend door actuator(s) are typically located on the climate control case behind the dashboard.

Where is my blend door actuator?

Where is the blend door actuator located? Remove the glove box and under-dash trim panels to find and replace the door actuator.

Where are all the blend door actuator located?

What are the Chevy Silverado blend door actuator problems?

A stuck blend door actuator can have you melting in the heat or freezing in the cold. Replacing those faulty units is unfortunately a tedious process, requiring removal of the entire dash, as explained here. This article applies to the Chevrolet Silverado 1500 (1996-2006). The heater blend doors act as a gateway to the vehicle’s ventilation system.

How does the Chevy Silverado blend door work?

When heat is built up inside of the heater core, the actuator door shifts to allow the hot air through the system, and when the climate control is turned to cool, the door flaps in the other direction closing off the heater core. Unfortunately, the blend doors on the Chevy Silverados contain plastic gears that tend to strip easily.

How do I replace the driver side blend door actuator?

For those interested in replacing the driver side actuator, refer to the following instructions: The driver-side blend door is accessed by removing the IP instrumental panel. Once the panel is off, simply loosen the actuator mounting screws and disconnect it from the HVAC system.

Why is my Chevy Silverado climate control stuck on one mode?

Unfortunately, the blend doors on the Chevy Silverados contain plastic gears that tend to strip easily. This causes the climate control to stay stuck on one specific temperature mode. There are two blend doors, one located on the driver side and another on the passenger side.