Why is my Whirlpool refrigerator not turning on?

The fridge may not turn on because of dirty condenser coils, power failures, incorrect temperature settings, problems with the door seal, or a faulty overload. If it won’t turn off, you should check the voltage board, thermostat, and condenser coils.

What is a starting device on fridge?

A starter device is commonly referred to as a refrigerator hard-start kit. Hard-start kits come in several varieties, but the best choice for the do-it-yourselfer is the 3-in-1 kit which combines the compressor’s overload relay, start relay and starting capacitor.

How does refrigerator compressor start?

Temperature sensors signal the compressor to start when the temperature inside the refrigerator rises above its set point. As the gas is compressed, its temperature goes up. The compressor pushes out the hot, compressed gas through the outside metal coils (tubes) on the back or bottom of the refrigerator.

How do you fix a fridge that won’t turn on?

INSPECT THE REFRIGERATOR POWER CORD

1. Unplug your refrigerator from power.
2. Check the power cord for damage.
3. Plug the cord back into the outlet.
4. Make sure the power cord is fully inserted.
5. Flip the circuit breaker to the unit off and then on.
6. If the power cord is found to be damaged it will need to be removed and replaced.

Is there a replacement part for the start device on a whirlpool?

This is a genuine replacement part. Whirlpool 2319792 Start Device for Refrigerator. Works with the following models: Whirlpool GD5VVAXTY00, Whirlpool GS5SHAXSL01, Whirlpool KSRS25RSBL00, Whirlpool KSRS25RSBL01, Whirlpool KSRS25RSBT00, Whirlpool KSRS25RSBT01, Whirlpool KSRS25RSMK00, Whirlpool KSRS25RSMK01, Whirlpool KSRS25RSMS00.

What is the rated voltage of the Whirlpool compressor start relay?

The Whirlpool Compressor Start Relay is a genuine OEM (Original Equipment Manufacturer) part designed and engineered to exact specifications Whirlpool WPW10197428 is rated at 115/127V and 60Hz The high quality Whirlpool Compressor Start Relay replaces W10128791, W10128795, W10197428, WPW10197428VP

How do I replace the start unit on my Kenmore dryer compressor?

Then find the old start unit on the left side of the compressor, remove the wire spring with needlenose pliers, carefully pry and remove the old start device from the compressor (comes off easy), then fish it out past the water lines so you can see the locking tab for the molex connector that the wires attach via.

What is the rated voltage of the Whirlpool wpw10197428?

Whirlpool WPW10197428 is rated at 115/127V and 60Hz The high quality Whirlpool Compressor Start Relay replaces W10128791, W10128795, W10197428, WPW10197428VP